이 교환은 9,350 방향이 L이라는 가정에서 적용됐으나, 단면 삽도(B5–B8 선, 교각축 직각 단면)와 재료표가 원래 배치(B1–B4 L 방향, B5–B8 W 방향)와 맞는 것으로 확인되어 되돌림.
Co-Authored-By: Claude Haiku 5.5 <noreply@anthropic.com>
- 재료표(B5–B8 9150 = 9350 − 2c, B1–B4 7600 = 7800 − 2c)와 같은 방향 배정으로 맞춤
- 격자 키를 물리 방향으로 정리: sL = L 방향 간격, sW = W 방향 간격 (기존 sAxis → sL, sPerp → sW)
- B1–B4: L 격자로 개수, 길이 W − 2c. B5–B8: W 격자로 개수, 길이 L − 2c
- B9: 열(L)은 sL, 행(W)은 sW 격자 (물리 격자 일치), 개수 불변
- B11은 L 방향 간격(sL), B12는 W 방향 간격(sW)
- 3D 확대기초 철근과 단면 그림의 역할을 교환 (B1–B4 선, B5–B8 점)
- 철근표 간격과 규칙 값, 설정 라벨을 방향 기준으로 수정
- 테스트 기대값 갱신 (B1–B4 40, B5–B8 31, B6 13646 분할 경고)
Co-Authored-By: Claude Haiku 5.5 <noreply@anthropic.com>
fyH and fyS become a grade per prefix (D · H · S), chosen from SD300 · SD400 · SD500. The defaults are the P1 values, so
the P1 results do not change. Each bar takes its grade from its 규격 (fyOf). The 철근표 has a 강도 column. Older files
that stored fyH / fyS are read into the grade map. Only fck is still an assumed value (I02). Approved 2026-10-23.
Co-Authored-By: Claude Haiku 5.5 <noreply@anthropic.com>
Each member can take its own fck on its ② card. A member without one uses the ③ 공통 fck, and fy stays common.
The rebar table and the 3D model both read the resolved value. The I02 note stays until every fck member has its
own value. The project file stores the values as optional fckByMember and refuses a bad value on open.
Changing the fck is not a shape change, so it is not counted in the pending changes.
Co-Authored-By: Claude Haiku 5.5 <noreply@anthropic.com>
